- Plug your Ethernet cable from the wifi router into the Pin-Pad cable (ETH).
Then plug your power cord into the Pin-Pad Cord.
- Write down the IP Address that shows up on the Pin-Pad screen during Boot-up.
- Go into iConnect iPad app > My Company > Peripheral Devices > Pin Pads > +
Type in the Pin-Pad IP Address into this section of iConnect.
Name can be whatever you’d like it to be. Leave Port as is.
Press the done or checkbox in the top right and iConnect will prompt you to enter a code into the Pin-Pad. Once you enter the code and the pin Matches you need to sync by pushing the sync button on the bottom left hand side of the screen. Then you are good to go with Pin-Pad transactions.