ICR touchscreen calibration

This article can be applied only to iCR POS units with a built-in grey printer. Newer models do not support the touchscreen calibration tool.

Franpos POS Calibration Setting and Check Firmware Version. Please download and install the Calibration software first http://apps.franpos.com/downloads/flytech_calibration.apk

 

 

1. Run the TP Assistant App.

 

2. Select the Upgrade Tool

 

3. Please make sure that you select the same settings as shown below

 

4. Press on Return

 

5. Press on Upgrade and select Calibration.

 

6. Press Calibration & Save.

• Related Articles

• ICR i connect POS ( User Mode to Admin Mode )

  Steps to switch ICR I Connect POS from User mode to Admin Mode. In order to uninstall the register app from ICR I Connect POS please switch the POS from user to Admin mode. 1. Go to the Settings of your ICR and tap on "Security" 2. Find "Login mode ...

• Set time on ICR

  1. Drag down time bar from left-upper corner on ICR 2. In order to open time menu press on clock itself 3. Set time, date, timezone, date format (Regional). See screenshots.

• Pax S300/ICR Hardware Setup

  Connecting ICR #1 to PAX #1 Go into the PAX #1 Settings to find the IP Address Select Menu/Function+1 Enter the password 1234, hit the GREEN enter button Arrow down once Select Communications Enter the password 1234, hit the GREEN enter button Arrow ...

• No Power to ICR register

  Hold the power button down for 5 to 10 seconds and the Green LED printer light should come on. If it does not power on, please check if it is plugged in correctly. Plug it into a surge protector, not directly into a wall outlet. Not plugging it in a ...

• ICR can't find built-in printer

  When the ICR can't find the built-in Printer, we suggest that you remove the back of your ICR, unplug all USB cables and restart your device. After that, please start your device and plug in the USB cables again.