QSR Drive Thru Sync Register Set up

QSR Drive Thru Sync Register Set up

Follow the steps below to enable local sync communication between your DT registers. 

Local sync should be turned off and kept off at front of house registers.

Steps on DT1 (drawer side):
  1. On register go to Settings > Devices > Local Sync Server
  2. Turn on "Enable local sync"
  3. Keep this devices role as Server
  4. Please note the "Server IP Address"
  5. Click "START SERVER"
  6. Allow the server to start and display 'Running"
On DT2 (order side)
  1. On register go to Settings > Devices > Local sync server
  2. Turn on "Enable local sync"
  3. Set this device's role to "Client"
  4. Enter in the IP address from DT1 server
  5. Make sure "Rescan network when connection lost" toggle is on
  6. Click "Keep Connecting to server"
On Dine In registers:
  1. On register go to Settings > Devices > Local sync server
  2. Verify "Enable local sync" is off


    • Related Articles

    • Local Sync orders not communicating between registers

      Steps to fix orders not appearing on Hold 1.     ON SERVER SIDE: o   SELECT (i) o   SELECT RESTART o   WAIT 30 SECONDS   2.     ON CLIENT SIDE: o   SELECT (i) o   SELECT RESTART   3.     ON CLIENT SIDE (IF NECESSARY) o   SELECT SETTINGS o   SELECT ...

    • Register Sync

      In order to sync transactions and customer information to other devices, the system will need to sync. The system will automatically sync every 15 minutes. Additionally, you can manually prompt it to sync the most current information at any time by ...

    • Detecto Scale - Set-up

      In this article, you will learn how to set up your Detecto scale using franpos register. - Follow this link to set-up your Detecto with Franpos: https://www.dropbox.com/s/9zpq1kv2g3sqyox/Detecto_scale_setup.mp4      

    • Set up eCommerce Orders on Your Register Settings

      Make sure the delivery set up is done on the back office first: https://support.franpos.com/portal/en/kb/articles/ecommerce-delivery To start receiving eCommerce orders on your register, follow these steps: Step 1: Navigate to eCommerce Settings 1. ...

    • Register Booking Settings

      Register app → Booking → Settings 1. You can either display all employees at once or just a specific one. 2. You can display employees based on the departments, which can be configured on the following page: https://my.franpos.com/Department 3. The ...