VX 805 Pin Pad Setup

VX 805 Pin Pad Setup

 

 

  1. Plug your Ethernet cable from the wifi router into the Pin-Pad cable (ETH).

Then plug your power cord into the Pin-Pad Cord.

  1. Write down the IP Address that shows up on the Pin-Pad screen during Boot-up.
  2. Go into iConnect iPad app > My Company > Peripheral Devices > Pin Pads > +

VX8051.png

Type in the Pin-Pad IP Address into this section of iConnect.

Name can be whatever you’d like it to be. Leave Port as is.

VX8052.png

Press the done or checkbox in the top right and iConnect will prompt you to enter a code into the Pin-Pad. Once you enter the code and the pin Matches you need to sync by pushing the sync button on the bottom left hand side of the screen. Then you are good to go with Pin-Pad transactions.

VX8053.png

    • Related Articles

    • Set up of ICT250 Semi-Integrated Pin-pad

      Before connecting, please make sure that the device matches the following information: SDK Version: 9.26.2 OS Version: 4614 App Version: 0604 You can find out about this as follows. Press the .,#* button Enter the password Go to the Terminal info ...

    • Capture signature on Pin-Pad

      In order to capture a signature on your Pin-Pad or to not capture signatures on your Register, please follow the steps below:   1. Press on "Settings" in your Register App 2. Tap on "Devices" 3. Tap on "Pin pad settings"   4. Enable "Capture ...

    • Verifone VX 805 Setup

      In this article, you will learn how to set up the Verifone VX 805 for your store.  Please note: This only works with the web/back office register.   Connect the VeriFone Mx\Vx Device via USB Install the x64-bit or x32-bit version of the VeriFone ...

    • Pax pin-pad auto registration (Broadpos)

      Franpos has released the new feature:  “PAX terminal: entering terminal SN in ICR settings allows to find terminal's new IP automatically. Requires "POS Auto-Register" option activated on BroadPOS portal” Here are the instructions on how to handle ...

    • Walk-in setup (iOS)

        Your POS system connects with our customer facing check-in module. The check-in module allows customers to check themselves into the service queue using the iPad kiosk. For example, your POS station (i.e. iPad cash register) will be in the back of ...