Scales
CAS SW10 / SW Series Connection to Franpos
In this article, we are going to show you how to connect the CAS SW series to a Franpos POS. Adapter Required: USB - RS232 with FTDI Support Type Settings on the scale need to be set to type 4. Please connect the original cable that came with the ...
Easy weigh scale setup
In this article, we will show you how to connect Easy Weigh scales to Franpos POS. Adapter Required: USB - RS232 with FTDI Support Please see the image below for the cable connection setup: 1. Connect the RS232-RS232 cable that came with the scales ...
VIVA TOLEDO SCALE SETUP STEPS
VIVA TOLEDO SCALE SETUP STEPS https://www.manualslib.com/manual/861274/Mettler-Toledo-Viva.html?page=15#manual This scale requires the two cables for it to work properly. To enter config – While powering on the scale, hold 0 Use T key to cycle ...
Detecto scale units mismatch
When you see the error message "Units mismatch" on your Register, please make sure to check which measurement was selected under the product. If your scale is set to "lb", please make sure to select "lb" under the product you are trying to sell. ...
How to change units on the Detecto scale
This article describes how to switch the Detecto scale units from lb to kg: Initial Setup: 1. Enter the Setup Mode by pressing calibration switch on the back of the scale with a thin object. 2. Scale screen should display word "Type". 3. Press Unit ...
Detecto Scale - Set-up
In this article, you will learn how to set up your Detecto scale using franpos register. - Follow this link to set-up your Detecto with Franpos: https://www.dropbox.com/s/9zpq1kv2g3sqyox/Detecto_scale_setup.mp4
Cas scale set-up
In order to use a new CAS scale with Franpos, please follow the steps below. Change ECR type setting in CAS scale to Type 5 (image of CAS manual below): Using power switch on the side, turn the scale off, press “# or T" key on the display ...